Other Products from Adafruit
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Topics
- Replies
- Views
- Last post
-
-
ATMega32u4 breakout - bootloader timeout
- 0 Replies
- 23 Views
- Last post by rihob
-
Thought for a combined board?
- 2 Replies
- 45 Views
- Last post by tonyd3
-
SHT-30 vs SHT-10 sensors
- 0 Replies
- 123 Views
- Last post by iesre
-
Tap Detection on Adafruit_FXOS8700 and FXAS21002C
- 3 Replies
- 34 Views
- Last post by mikeysklar
-
Negative pressure room
- 1 Replies
- 18 Views
- Last post by adafruit_support_bill
-
unable to connect thermal printer guts with raspberry pi
- 0 Replies
- 15 Views
- Last post by taggys
-
DIY USB or HDMI Cable Parts - 5 cm Ribbon Cable inquiry
- 2 Replies
- 103 Views
- Last post by SpoonFpv
-
PM2.5 AQI sensor units?
- 4 Replies
- 810 Views
- Last post by mikeysklar
-
I have a goal where are the plans?
- 1 Replies
- 25 Views
- Last post by adafruit_support_bill
-
Get fingerprint Image
- 2 Replies
- 44 Views
- Last post by adafruit2
-
Connector Dims for SWD (2x5 1.27mm) Cable Breakout Board
- 1 Replies
- 31 Views
- Last post by EnlitenAudio
-
Load on LiPo charger v1?
- 2 Replies
- 17 Views
- Last post by FishEatPork
-
QFN28 breakout?
- 0 Replies
- 19 Views
- Last post by jensa
-
The missing Silicone Jumper wire...
- 4 Replies
- 40 Views
- Last post by jensa
-
Defective unit
- 1 Replies
- 25 Views
- Last post by jbaumchen
-
M5Stick-C - what current can the +5V supply?
- 2 Replies
- 29 Views
- Last post by PThompson509
-
MiCS5524 Gas sensor and general analog question
- 0 Replies
- 50 Views
- Last post by Quasimodem
-
MagPi Home Monitoring dashboard
- 0 Replies
- 14 Views
- Last post by Tom_Henry
-
Cricket micro:bit robot: Can you control from iOS?
- 2 Replies
- 43 Views
- Last post by adafruit2
-
Current Sensors
- 0 Replies
- 24 Views
- Last post by Zaemo
-
STRETCH SENSOR SPEC
- 1 Replies
- 37 Views
- Last post by Franklin97355
-
MiniBoost 3661 - Low battery protection & EN
- 1 Replies
- 75 Views
- Last post by adafruit_support_mike
-
difference between 2472 and 4646 imu breakout boards
- 3 Replies
- 94 Views
- Last post by adafruit_support_mike
-
USB Isolator (product ID 2107) heats up
- 4 Replies
- 170 Views
- Last post by adafruit_support_mike
-
Mode in Adafruit_ZeroI2S library
- 0 Replies
- 45 Views
- Last post by hopskipjump
-
SHT-30 Mesh-protected Weather-proof Temperature/Humidity Sen
- 0 Replies
- 28 Views
- Last post by adaroberto
-
DHT22 (am2302) reading 0
- 0 Replies
- 31 Views
- Last post by bobs409
-
Can the MLX90393 detect cars at far range?
- 3 Replies
- 112 Views
- Last post by adafruit_support_bill
-
4260
- 1 Replies
- 31 Views
- Last post by adafruit_support_mike
-
Fuel-gauge board behavior when charging ?
- 1 Replies
- 53 Views
- Last post by adafruit_support_mike
-
Turn off Power LED on APDS9960
- 3 Replies
- 105 Views
- Last post by thanhan1
-
Measuring high humidity with SHT31-D board
- 6 Replies
- 78 Views
- Last post by chinswain
-
Arduino and Neopixels
- 2 Replies
- 28 Views
- Last post by adafruit_support_carter
-
Snake Eyes Bonnet for Raspberry Pi - lots of issues
- 15 Replies
- 142 Views
- Last post by adafruit_support_carter
-
ESP32 save the SGP30 baselines using EEPROM library
- 1 Replies
- 527 Views
- Last post by mrsmtt
-
Questions about AS7341 10-Channel Color Sensor ...
- 3 Replies
- 503 Views
- Last post by adafruit_support_bill
-
SGP30 CO2 Sensor - Calibration OK, but what about that "once
- 18 Replies
- 3158 Views
- Last post by adafruit_support_bill
-
HDMI 7" 800x480 Display Backpack - With Touchscreen - Touchs
- 9 Replies
- 88 Views
- Last post by Pmmoore2
-
SGP30 readings not changing, sensor not heating up (as it sh
- 1 Replies
- 400 Views
- Last post by mikeysklar
-
How to pause Madgwick filter? W/ NXP Precision 9-DOF IMU
- 3 Replies
- 43 Views
- Last post by sid8580
-
Two T/RRH sensors in agreement
- 8 Replies
- 98 Views
- Last post by iesre
-
Solar Lithium Ion/Polymer charger V2 - Blinking DC-IN and Bl
- 10 Replies
- 352 Views
- Last post by adafruit_support_bill
-
Powerboost 1000 Basic battery protection??
- 4 Replies
- 121 Views
- Last post by iqasi096
-
Adafruit 1000c "Low" Light Blinking
- 5 Replies
- 57 Views
- Last post by alphanumeric
-
TFT Friend odd behavior - draws 700mA
- 10 Replies
- 190 Views
- Last post by adafruit_support_mike
-
Multiple INA260 with common Ground
- 0 Replies
- 36 Views
- Last post by p8mty
-
Sound cuts out using 2.5W mono amp (PAM8302) and RPi4
- 0 Replies
- 34 Views
- Last post by dkadish
-
Need old revision of 3316, Adafruit VL6180X Time of Flight D
- 4 Replies
- 53 Views
- Last post by adafruit2
-
Help with DHT22 (am2302) error messages
- 2 Replies
- 266 Views
- Last post by bobs409
Please be positive and constructive with your questions and comments.
-