I use the Minipov3 kit under linux (Ubuntu 11.10) with the PL-2303 conterter.
When I try to compile a sample, I've got en error:
Code: Select all
$ make program-minipov
avrdude -p attiny2313 -P /dev/ttyUSB0 -c dasa -U flash:w:minipov.hex
avrdude: AVR device not responding
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude done. Thank you.
make: *** [program-minipov] Erreur 1
I've read a topic where somebody use the port /dev/ttyS0. If I do this, I get the same error without the blinking leds.
I've checked my soldering a few times.
I try the special version of avrdude but It didn't change anything.
I also try under Windows but avrdude don't find the com port. I'm sure this one is well configured!
So, I would like to know: Is it normal to get the three blinking leds during programming? Do you have an idea of my mistake?
Thanks a lot