Sensor
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88097
- Joined: Sat Feb 07, 2009 10:11 am
Re: Sensor
The standard miniPOV firmware just repeats the image display continuously. With some programming changes, you can use a sensor to trigger the start of the display. For example, the SpokePOV uses a hall-effect sensor & magnet to trigger the start of the display at the same point of each wheel rotation.
- edwinp1
- Posts: 1
- Joined: Mon Jan 05, 2015 12:05 pm
Re: Sensor
Couple questions:
Tactile Alternating Button w/3 Wire Leads(id: 1685)--is this item water
resistant?
PIR Sensor (id: 189)--is there a built-in visual indicator that indicates a
violation when the PIR senses movement?
Tactile Alternating Button w/3 Wire Leads(id: 1685)--is this item water
resistant?
PIR Sensor (id: 189)--is there a built-in visual indicator that indicates a
violation when the PIR senses movement?
- adafruit_support_bill
- Posts: 88097
- Joined: Sat Feb 07, 2009 10:11 am
Re: Sensor
It is not sealed against water.Tactile Alternating Button w/3 Wire Leads(id: 1685)--is this item water
resistant?
There is no indicator led on the board.PIR Sensor (id: 189)--is there a built-in visual indicator that indicates a
violation when the PIR senses movement?
Please be positive and constructive with your questions and comments.