Well, here i go!
Died at address 0
1. All the LEDs light up in sequence with power on, batteries in. At end of
sequece One led each side still iluminated, one side at top other side 6th counting from reset button.
2. One pulse on reset button. two led iluminated on this side, 9th and 30 th from reset button, other side led at top.
3. Other pulse on reset, only one led iluminated side reset button 30th , at bottom. And other pulse (large) all leds off.
R1 is 47 Ohm, and R4 1K
install giveIO.bat loaded, used closed and unclosed promt window.
I can´t probe on other computer because they have a monitor of 800x600.
Any idea?
And other question, what is the moment for programing (iluminated leds).
Thanks.
Programing issue
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
Please be positive and constructive with your questions and comments.