No Jumpers or straps in my kit
Moderators: Altitude, adafruit_support_bill, adafruit, phono, mome rath

No Jumpers or straps in my kit

by maclean on Sun Aug 26, 2012 11:55 am

Do I need anything specific for the jumper wires or can I just chop up a wire off an old device in the house? Also are the straps 100% needed for the two large selector knobs on the xoxbox? Is there anyway I can get round it other than obtianing the recommended wires?

These bits were missing from my kit :-(
Posts: 21
Joined: Mon Jul 16, 2012 7:43 pm

Re: No Jumpers or straps in my kit

by Luap on Sun Aug 26, 2012 12:21 pm

The jumpers are just wire. Even the straps are just wire. You wouldn't get that kind of thing in a kit because, well, it's just wire :wink: A consumable like solder etc.
I would fit the strap wires if you can. It will make the pots more secure and minimise the joints breaking in future. A bit of old solid core mains cable is good for that.
Posts: 359
Joined: Wed Jul 08, 2009 7:10 pm
Location: London'ish. UK