Memorial day is 05/25/2015 – Orders will ship out on May 26th. There will not be any deliveries or shipping on Monday. Any order placed after 11am ET on Friday May 22nd will not start to ship out until Tuesday May 26th.

Wire to wire connectors
Moderators: Altitude, adafruit_support_bill, adafruit, phono, mome rath

Wire to wire connectors

by rarara on Tue Feb 26, 2013 8:16 am

Am about to get molex connectors for linking main and io boards. I also need to rewire a whole lots of my bcbox I/O mod connectors. These tend to just be a piece of wire from say a pad on the I/O board to the log of a component on the main board. Obviously they are not candidates for molex-ing. I believe that what I really need is a wire-to-wire connector. There most be about a dozen wires in total, so either something with 12 pins, or maybe easier a couple of six pins.

I have searched and am struggling for something suitable. Found JST-EHR connectors but the only pre-wired seem to be the 2 pin which would make things expensive. Maybe I will need to crimp the existing leads to a non-wired connector?

Anyone done this and can recommend a suitable product?
rarara
 
Posts: 169
Joined: Wed Apr 05, 2006 9:47 am

Re: Wire to wire connectors

by altitude on Wed Feb 27, 2013 8:40 am


altitude
 
Posts: 981
Joined: Wed May 11, 2005 5:17 pm