Hi. My English is not good but hope you understand me.
When I soldered parts on VCF section, I soldered Q10 in the opposite direction by mistake.
Thereby, it seems that Q21 and C27 was broken.
After replacing them, pin 1 and pin 6 of VR4 still made no signal.
I checked all R and C value, they looks correct value.
Then, I measured all voltages on VCF section, and compared with voltages of Eagle layout which is published in Analogue
Section Reference Voltages thread. I found that some point showed different value, and they show blue figures in attachment.
However, I can't understand what it is caused by.
So, please tell me what shoud I do.
Troubleshooting:VCF problem
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- Zvezda
- Posts: 1
- Joined: Mon Nov 10, 2014 9:58 am
Troubleshooting:VCF problem
- Attachments
-
- d1.jpg (480.24 KiB) Viewed 1350 times
Please be positive and constructive with your questions and comments.