So I've been building a WillyXYZ x0x recently and I ran into issues with the power supply. Following the adafruit guide I ended up with all the correct voltages up until it was time to measure the output, where it the voltages (according to my multimeter) reach the 1000s... I traced some voltages according to schematics I found and everything lined up before IC22... so I ordered a new one. But replacing it didn't change anything
I'm stumped. Any ideas?
Power Voltage Far Too High
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- Pyjamas
- Posts: 6
- Joined: Thu Apr 30, 2015 11:01 am
Re: Power Voltage Far Too High
I have quite the same problem. My power supply voltage is to low instead. 9.6 V against expected 12 V.
Please be positive and constructive with your questions and comments.