click be gone mod for the ba662a

[gurth]

hi overthere,

I got some kind of problem, I bought a nice x0x0x with a ba6110 vca in it, it has an 1k resistor from base of Q1 & 1 uf 25volt tantalum to ground to get rid of clicks, which works real nice. Now I bought an ba662a and wondered were should I solder the click be gone mod to get rid of the clicks from the ba662???

Thanks very much in advance

[Altitude]

yes, take it out. I am not sure if you can leave the current mirror in there or if you have to take that out as well (the 2 pairs of transistors)

[gurth]

Thanks for the reply.

But I think I was not clear enough, gonna try it again.

I have a click be gone mod on my ba6110, but going to use a ba662a. The ba662a vca clicks without the mod so I want the mod soldered so that it gets rid of the clicks made by the ba662a.

On what pin do I have solder that mod to get it working with the ba662a vca.

thanks again

gurth