Memorial day is 05/25/2015 – Orders will ship out on May 26th. There will not be any deliveries or shipping on Monday. Any order placed after 11am ET on Friday May 22nd will not start to ship out until Tuesday May 26th.

click be gone mod for the ba662a
Moderators: Altitude, adafruit_support_bill, adafruit, phono, mome rath

click be gone mod for the ba662a

by gurth on Wed May 23, 2012 5:38 pm

hi overthere,

I got some kind of problem, I bought a nice x0x0x with a ba6110 vca in it, it has an 1k resistor from base of Q1 & 1 uf 25volt tantalum to ground to get rid of clicks, which works real nice. Now I bought an ba662a and wondered were should I solder the click be gone mod to get rid of the clicks from the ba662???

Thanks very much in advance
gurth
 
Posts: 12
Joined: Fri Apr 24, 2009 7:52 am

Re: click be gone mod for the ba662a

by altitude on Thu May 24, 2012 11:04 am

yes, take it out. I am not sure if you can leave the current mirror in there or if you have to take that out as well (the 2 pairs of transistors)

altitude
 
Posts: 981
Joined: Wed May 11, 2005 5:17 pm

Re: click be gone mod for the ba662a

by gurth on Fri May 25, 2012 12:19 pm

Thanks for the reply.

But I think I was not clear enough, gonna try it again.

I have a click be gone mod on my ba6110, but going to use a ba662a. The ba662a vca clicks without the mod so I want the mod soldered so that it gets rid of the clicks made by the ba662a.

On what pin do I have solder that mod to get it working with the ba662a vca.

thanks again

gurth
gurth
 
Posts: 12
Joined: Fri Apr 24, 2009 7:52 am