what's the current being pumped out of these inputs?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 76
- Joined: Sun Feb 04, 2007 9:47 pm
what's the current being pumped out of these inputs?
my mpc1000 sends 3.3 volts to its sensors. what about midisense?
-
- Posts: 76
- Joined: Sun Feb 04, 2007 9:47 pm
excellent....that's good news.
why i'm asking is because i want to run these things on a parallel circuit instead of 1 sensor to 1 input.
i want to run 2 pressure sensors onto 1 input parallel, both triggering a snare note. one sensor will have a resistor placed so that its current is diminished, resulting in a lower ceiling of potential loudness - while the other will be uninhibited. it'll take a lot of fooling around, but i'm incredibly excited about the possibilities here.
why i'm asking is because i want to run these things on a parallel circuit instead of 1 sensor to 1 input.
i want to run 2 pressure sensors onto 1 input parallel, both triggering a snare note. one sensor will have a resistor placed so that its current is diminished, resulting in a lower ceiling of potential loudness - while the other will be uninhibited. it'll take a lot of fooling around, but i'm incredibly excited about the possibilities here.
Please be positive and constructive with your questions and comments.