Ok got everything soldered into position, but when I go to measure for 5 volts I am getting 1.35 vdc and when I measure 2 V I get .35 Vdc?? I did a quick check of the solder joints they look ok. See attached pics...thanks for any help.
Sorry for the pics...its the best I can get under a magnifying glass and my cheap camera.
MintyBoost not working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 3
- Joined: Fri Oct 19, 2012 7:58 am
MintyBoost not working
- Attachments
-
- back
- P1010177.JPG (100.54 KiB) Viewed 1101 times
-
- front
- P1010180.JPG (90.81 KiB) Viewed 1101 times
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: MintyBoost not working
Your LT1302 chip is installed backwards. The notch should align with the notch indicated in the silkscreen.
-
- Posts: 3
- Joined: Fri Oct 19, 2012 7:58 am
Re: MintyBoost not working
Ok, duh! I had the chip in backwards...just caught that. Now I am reading 4.98 Vdc and 1.98Vdc.
Please be positive and constructive with your questions and comments.