Minty boost circuit
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- puneet08466
- Posts: 2
- Joined: Wed Feb 25, 2015 7:42 pm
Minty boost circuit
I have accidently damaged +ve input point on the circuit board , is it ok to solder +ve input to c1 directly ?
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: Minty boost circuit
Yes. As long as no other traces were broken, that should work.
- puneet08466
- Posts: 2
- Joined: Wed Feb 25, 2015 7:42 pm
Re: Minty boost circuit
thanks it works for connection, I get output voltage of 4.94 V on USB outer pins , i have soldered the inner 2 pins of USB as per instructions.
but when I connect iphone 5 , I get error message "this accessary may not be supported"
I have changed AA batteries (duracell, ikea, reachargeable), what should be my input voltage to be able to make it work?
but when I connect iphone 5 , I get error message "this accessary may not be supported"
I have changed AA batteries (duracell, ikea, reachargeable), what should be my input voltage to be able to make it work?
- Franklin97355
- Posts: 23910
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Minty boost circuit
This isn't a power issue but a phone negotiation issue. the inner connections have to be correct for the phone to recognize the charger."this accessary may not be supported"
Please be positive and constructive with your questions and comments.