jamner with biometric authentication
Moderators: adafruit_support_bill, adafruit

jamner with biometric authentication

by pilas on Fri Dec 16, 2011 3:02 pm

Ok. am from university of ghana. doing a jammer as a final year project, i call it an intelligent gsm signal neutralizer , jammers are not illegal here by law plus a lot of car accidents are as a result of cell phone use by driver . i checked out ladyada's project on wave bubble, and i wanna do the same thing but due to the fact that unscrupulous persons can use this device for evil, i decided to inculcate a finger print authentication system so that the right people will only have access to the device. i was thinking on the micro-controller to use and the type of finger print module. i will appreciate any suggestion. thankx.. open source for life.
Posts: 7
Joined: Wed Dec 14, 2011 3:32 pm

Re: jamner with biometric authentication

by asselinpaul on Tue Dec 20, 2011 4:12 pm

Here you go: http://www.sparkfun.com/products/8881
Sparkfun only because Adafruit does not have this type of product.
This should be pretty simple if you know how to build a jammer.
Best of Luck
Posts: 7
Joined: Tue Oct 05, 2010 1:57 pm