Fixes to rc1

The operation of transmitters designed to jam or block wireless communications is a violation of the Communications Act of 1934, as amended ("Act"). See 47 U.S.C. Sections 301, 302a, 333. The Act prohibits any person from willfully or maliciously interfering with the radio communications of any station licensed or authorized under the Act or operated by the U.S. government. 47 U.S.C. Section 333. The manufacture, importation, sale or offer for sale, including advertising, of devices designed to block or jam wireless transmissions is prohibited. 47 U.S.C. Section 302a(b). Parties in violation of these provisions may be subject to the penalties set out in 47 U.S.C. Sections 501-510. Fines for a first offense can range as high as $11,000 for each violation or imprisonment for up to one year, and the device used may also be seized and forfeited to the U.S. government.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
shadowmite
 
Posts: 3
Joined: Thu Dec 28, 2006 9:37 pm

Fixes to rc1

Post by shadowmite »

So, according to your downloads page we need to make some fixes to the design before sending off for PCB's. Is it primarily this lmx243x chip pin 13 that needs the cap added? Or can you point me in the right direction here?

adafruit
 
Posts: 12151
Joined: Thu Apr 06, 2006 4:21 pm

Post by adafruit »

the step for the PLL says in detail where to put the small caps: on top of the 10K resistors from the IF out and RF out. also shown in the pictures.

shadowmite
 
Posts: 3
Joined: Thu Dec 28, 2006 9:37 pm

Post by shadowmite »

I did notice that a little bit later reading through, thanks for the response though!

User avatar
rc:line
 
Posts: 9
Joined: Thu Dec 28, 2006 12:43 am

Post by rc:line »

And all the resistors are (intentionally?) shown backwards... :x

adafruit
 
Posts: 12151
Joined: Thu Apr 06, 2006 4:21 pm

Post by adafruit »

rc:line wrote:And all the resistors are (intentionally?) shown backwards... :x
uh, can you be more specific about what you're talking about?

User avatar
rc:line
 
Posts: 9
Joined: Thu Dec 28, 2006 12:43 am

Post by rc:line »

I was just kidding...

I thought it was funny after reading this comment:
http://www.hackaday.com/2006/12/25/wave ... /#c1214184

adafruit
 
Posts: 12151
Joined: Thu Apr 06, 2006 4:21 pm

Post by adafruit »

:P

Locked
Please be positive and constructive with your questions and comments.

Return to “Wave Bubble”