I'm assembling a SpokePOV kit with an older v1.0b PCB. I've encountered trouble while following the website assembly directions which show a version v1.1 board. I"m not exactly sure where to put the capacitors as its not listed on my board (or I can't tell). Is there a diagram or photo of the v1.0b version?
Any help is greatly appreciated. Thanks!
..marko
Help using SpokePOV PCB v1.0b
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 4
- Joined: Sun Sep 27, 2009 4:31 am
Re: Help using SpokePOV PCB v1.0b
The capacitor was not included in the version 1 PCB and is not required
Please be positive and constructive with your questions and comments.