Memorial day is 05/25/2015 – Orders will ship out on May 26th. There will not be any deliveries or shipping on Monday. Any order placed after 11am ET on Friday May 22nd will not start to ship out until Tuesday May 26th.

2 long, 1 short: Will it work?
Moderators: adafruit_support_bill, adafruit

2 long, 1 short: Will it work?

by noob_for_life on Fri Jul 06, 2012 1:56 am

My 13 year old must have been a little to eager to build this SpokePOV because his missed something critical in the instructions. When he got to the part about cutting the board for BMX and kids bikes, he just read that he should cut the board . . . and did.

Now he has two long boards and one that was cut. He's not sure he wants to spend the money to replace the short board. He's wondering what would happen if he sent a design created for long boards to the short one? Or does he create an edited drawing for the short board?


Posts: 8
Joined: Wed May 07, 2008 4:18 pm

Re: 2 long, 1 short: Will it work?

by adafruit_support_bill on Fri Jul 06, 2012 5:41 am

The 'long board' pattern will be truncated where the board is cut. If you are putting all three on the same wheel, load the same pattern on each. The missing section will appear slightly dimmer when the wheel rotates.

Posts: 37552
Joined: Sat Feb 07, 2009 10:11 am