help!!! project due tmw!!
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 5
- Joined: Sat Feb 09, 2013 10:42 pm
help!!! project due tmw!!
Hi all! the spokepov kit was my electronics project for class and its due tmw! i finally got the programming image part down but now im having trouble getting it to light up. if i wave the magnet in front of the sensor, itll light up for a few seconds and then power down. ive tried attaching the magnet to the frame of my bike but i think its too far for the sensor to detect the magnet. any suggestions on how to fix this?
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: help!!! project due tmw!!
Can you post photos of how you have it mounted now?
-
- Posts: 5
- Joined: Sat Feb 09, 2013 10:42 pm
Re: help!!! project due tmw!!
im not with my bike at the moment. but now i have literally placed the magnet on top of the sensor. would this work at all?
-
- Posts: 5
- Joined: Sat Feb 09, 2013 10:42 pm
Re: help!!! project due tmw!!
i also tried attaching popsicle sticks to the frame so the magnet could be closer. but still nothing.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: help!!! project due tmw!!
If you can get it within 1/8" or so it should be fine. Make sure you have the magnet facing the right way. The hall sensor only works with one side of the magnet.
Please be positive and constructive with your questions and comments.