Single spokePOV cycles leds then 3 light up... and thats it
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 3
- Joined: Fri Feb 22, 2008 4:28 pm
Single spokePOV cycles leds then 3 light up... and thats it
Sensor doesn't seem to be doing any thing when waved past magnet. 2 Leds light on one side and 1 on the other after putting in batteries. The lights that stay on are the same as addressed in a previous post by feinberj, but I only have the one so I imagine its not the trace that needs cutting...
-
- Posts: 31
- Joined: Wed Jan 30, 2008 11:01 am
you seem to get 3 lights when you press the reset button. It doesn't seem to be a problem.
Are you waving the red line side of the magnet facing the sensor?
Have you got the sensor soldered in the right way around?
Usual question past that is post a good quality photo for someone here to take a look at and see if there are any mistakes on the boards.
Are you waving the red line side of the magnet facing the sensor?
Have you got the sensor soldered in the right way around?
Usual question past that is post a good quality photo for someone here to take a look at and see if there are any mistakes on the boards.
-
- Posts: 3
- Joined: Fri Feb 22, 2008 4:28 pm
Please be positive and constructive with your questions and comments.