Using an arduino as a ISP dongle
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 4
- Joined: Sun Apr 27, 2014 9:00 pm
Using an arduino as a ISP dongle
I attempted to make an ArduinoISP with the attiny2313 chip on a breadboard, then use the SpokePOV software (on Windows) to connect with it. It made the ISP status LEDs blink, but errored out. Is this not really supported by the SpokePOV software because there is something different about the USBtinyISP?
Last edited by yincrash on Sun Apr 27, 2014 10:35 pm, edited 1 time in total.
-
- Posts: 4
- Joined: Sun Apr 27, 2014 9:00 pm
Re: Using an arduino as a ISP dongle
Hmm. Would it work if I just put 1.5K resistors on the SCK and MOSI line of the ArduinoISP then used a 10pin header to connect it to the board?
Please be positive and constructive with your questions and comments.