Reflow Skillet parts
Moderators: adafruit_support_bill, adafruit

Reflow Skillet parts

by unridiculous on Fri May 08, 2009 1:22 pm

Question for ladyada -

Do you have any advice for where to get the acryllic parts cut for your reflow skillet?
Would you be willing to sell an extra set that you may or may not have.
Thanks again.
unridiculous
 
Posts: 3
Joined: Fri May 08, 2009 1:11 pm

Re: Reflow Skillet parts

by adafruit on Mon May 11, 2009 3:21 pm

they're on thingiverse. you could send them to ponoko or go to your local plastics shop (see your yellow pages)
User avatar
adafruit
 
Posts: 11711
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc

Re: Reflow Skillet parts

by scottjg on Sun Dec 06, 2009 11:11 pm

Also, is that some kind of grip tape around the dial on the skillet? Where did you procure that from? I'm thinking of doing something like this for the dial-controlled radiator in my apartment.
scottjg
 
Posts: 1
Joined: Sun Dec 06, 2009 11:05 pm

Re: Reflow Skillet parts

by adafruit on Sun Dec 06, 2009 11:47 pm

its just foam tape, any hardware store has it
User avatar
adafruit
 
Posts: 11711
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc