Laser cutting holes in project boxes?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 164
- Joined: Fri Jun 11, 2010 9:21 pm
Laser cutting holes in project boxes?
How good are cheapo (40W) cutters at cutting holes in ABS, as used for most cheap project boxes from Hammond etc.?
-
- Posts: 57
- Joined: Sun Jun 20, 2010 7:53 am
Re: Laser cutting holes in project boxes?
As long as its no thicker than 2-3mm it should cut ok although we noticed that with dodgy acrylic it would leave a dodgy edge.
Here is a cheap chinese job in action: http://www.youtube.com/watch?v=StN3RwXZ ... re=related
Here is a cheap chinese job in action: http://www.youtube.com/watch?v=StN3RwXZ ... re=related
Please be positive and constructive with your questions and comments.