Just purchased a Zing 16, but I can't seem to get it to work with my Mac Pro system. I've tried using installing the driver to use the USB port and also the TCP/IP port but, while the install seems to go fine, I can't get anything to show up on the Zing. It always says no jobs loaded. I read somewhere that Adafruit was considering using Parallels with their Epilog lasers, so I was hoping perhaps someone there could help out. Or, if anyone lease has advice, that would be appreciated, too.
Wayne
Epilog Zing with Parallels running 64 Bit Win 7
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- wholder
- Posts: 59
- Joined: Mon Mar 16, 2009 2:09 pm
Please be positive and constructive with your questions and comments.