Hello,
I believe this is the correct place to ask this question. If not please redirect me and apologies in advance.
I just received adafruit's beginner's electronics package. Super happy with it and had a lot of fun learning how to solder the protoshield together on the Arduino package I also just received. However, the MASTECH (MAS830) multimeter that was sent now continuously buzzes when using the continuity test setting. It was not doing this yesterday so I believe it is broken, it used to only buzz when the circuit was completed like it is supposed to. I have not dropped it or anything and it is only a week old. Is there a way to get it replaced through Adafruit?
Thanks in advance!
Multimeter Broken
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: Multimeter Broken
So it buzzes as soon as you turn the dial to the continuity test? Even with the leads unplugged?
-
- Posts: 2
- Joined: Fri Nov 02, 2012 10:56 pm
Re: Multimeter Broken
That is correct. With the jumpers disconnected the meter buzzes and will not stop as soon as it is turned to the continuity test setting. Anything I can do to fix this?
Thanks for the reply.
Thanks for the reply.
- adafruit_support_bill
- Posts: 88096
- Joined: Sat Feb 07, 2009 10:11 am
Re: Multimeter Broken
Contact [email protected] with a link to this thread for a replacement.
Please be positive and constructive with your questions and comments.