Hi everyone, I build this great project (V2) and flash attiny with maked .hex from spi folder. Succesfuly instal com0com port emulator and USB Tiny 500.
On my pc USB port I connect onlu Tiny ISP (without target device). I have latest version of AVR studio 4 instaled.
Here what is happened:
When i click (in AVR studio) Tools/Program AVR/Conect, and choose platform:AVRISP; port:COM2
new form "STK500/AVRISP" is pop up and ask me:
An STK500 with firmware version 2.00 has been detected. The fermware version corresponding to this installation of AVR Studio is 2.0A. Pres OK to launch the upgrade program to perform an upgrade, or Cancel to continue without upgrading. NOTE! Correct operation is not guaranteed if an upgrade is not performed. AVR Studio will close down.
When i click "CANCEL" I get the ISP error Mode message
A problem occurred when executing the command. Make sure that you are using the correct programming method. Current mode is ISP. See the command output for more info.
On bottom of "STK500 with top module..." i have information:
Setting mode and device parameters...OK!
Entering programming mode...FAILED!
Leaving programming mode...OK!
I think something is wrong...
Any help, please.