experimentation pack -- fuse settings?
Moderators: adafruit_support_bill, adafruit

experimentation pack -- fuse settings?

by nflowers on Sun Jan 29, 2012 1:36 pm

Hey folks,

Excitedly received and unwrapped my experimentation kit, starting to tinker.

Does anyone know if the fuses are properly set when the uno is shipped? I've opted to use command-line interface rather than the IDE, and after reading all the cautions about bricking your chip, would rather not type anything potentially dangerous (like writing fuses) into avrdude until I understand better what I'm doing.

For what it's worth, the "blinky light" sketch works fine. If the fuses were misconfigured, I assume there would be some spectacular kind of failure mode?

Thanks.
nflowers
 
Posts: 3
Joined: Sun Jan 29, 2012 1:31 pm

Re: experimentation pack -- fuse settings?

by adafruit on Sun Jan 29, 2012 1:53 pm

yes the fuses are set, don't change the fuses!
User avatar
adafruit
 
Posts: 11740
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc

Re: experimentation pack -- fuse settings?

by nflowers on Sun Jan 29, 2012 1:59 pm

great news, thank you, i love it already! i can't wait to have an army of robots at my command.
nflowers
 
Posts: 3
Joined: Sun Jan 29, 2012 1:31 pm