LedBeltKit not in sync: resp=0x3f

[jandrade]

Hi I just got my LedBeltKit. Assemblig Ok, Compiling Ok but when running I got following message:
Binary sketch size: 6,456 bytes (of a 30,720 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x3f

please advice

thanks

Johnny

[adafruit_support_bill]

What OS are you running? Have you installed the Teensyduino package?

[jandrade]

HI, thanks for your reply

I am running on Windows XP. I downloaded Teensdduino but not sure what do I need to Install.

thanks

Johnny

[adafruit_support_bill]

If you unzip it, there is an Arduino IDE inside. Are you running that one? Make sure you select the Atmega32U4 break out as the board type be sure to press the reset button on the board as you upload.

[jandrade]

Actually there is no Atmega32U4 break out as the board type in drop down tools menu, just Atmega328, from Arduino Duemilanove all the way to Arduino NG

thanks

[adafruit_support_bill]

Are you sure you are running the IDE that is in the TeensyDuino download? It should have Teensy & 32U4 options as well.

[jandrade]

Yes, you were right. Didnt know there were two version. Now I have the correct one and board is showing up.

Now I am getting this error
Connecting to programmer: .avrdude: ser_send(): write error: sorry no info avail

thanks a lot for your help

Johnny

[adafruit_support_bill]

Make sure you have the right COM port selected. If you still have problems, hold down the shift-key when pressing the upload button and post the diagnostic output.

[jandrade]

HI Marco

I just got the Lightbelt working fine. You are the best. thanks a lot for your help

Johnny

[jandrade]

Hi Marco

I have a question. LedBeltKit is already wotking with original Arduino program. My quesiion is if I RE-programe or change to a different sequence ?how do I make my Belt to take the new program?

thanks for your time

Johnny

[adafruit_support_bill]

If you connect the teensy to your computer, you should be able to upload the new program with the upload button in the IDE.