Micro Servo Burnt Out
Moderators: adafruit_support_bill, adafruit

Micro Servo Burnt Out

by rahatmaini on Sun Feb 24, 2013 7:37 pm

I accidentally supplied Ground to power and power to Ground to my Micro Servo. Is there any way to fix this that is not relatively complex?

rahatmaini
 
Posts: 165
Joined: Wed Aug 29, 2012 5:15 pm

Re: Micro Servo Burnt Out

by adafruit_support_bill on Sun Feb 24, 2013 8:30 pm

I assume from the question that it does not work if the correct connections are supplied? The servo connector is cleverly designed so that even if you connect in in reverse (Gnd->Signal, VCC->VCC, Signal->GND), no damage will occur. I haven't experienced a Gnd->VCC/VCC->Gnd connection. But I don't expect it would be healthy for the servo control circuit. :(
User avatar
adafruit_support_bill
 
Posts: 31684
Joined: Sat Feb 07, 2009 10:11 am