I have several small breakout boards such as the PowerBoost 1000B (2030), the 16 Channel 12-bit PWM Driver (815), and the L3G20H Gyro (1032). They each have small mounting holes at or near each corner. I would like to know what Adafruit (or others) recommend for mounting hardware.
NOTE: I will be mounting these and/or other boards inside a small project box(es).
What Hardware to Use For Adafruit/Arduino Breakout Boards
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- seanmc2
- Posts: 7
- Joined: Thu Jan 15, 2015 10:31 pm
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: What Hardware to Use For Adafruit/Arduino Breakout Board
We use M2 screws.
We don't carry those (too many sizes, and we'd have to charge too much markup), but you can get them from suppliers like http://www.microfasteners.com/ or http://www.mcmaster.com/
We don't carry those (too many sizes, and we'd have to charge too much markup), but you can get them from suppliers like http://www.microfasteners.com/ or http://www.mcmaster.com/
Please be positive and constructive with your questions and comments.