Problems With Upload on nrf8001

[kenyajr]

Arduino: 1.6.1 (Windows 7), Board: "Arduino Uno"

Build options changed, rebuilding all



Sketch uses 10,008 bytes (31%) of program storage space. Maximum is 32,256 bytes.

Global variables use 1,110 bytes (54%) of dynamic memory, leaving 938 bytes for local variables. Maximum is 2,048 bytes.

avrdude: ser_open(): can't open device "\\.\COM3": The system cannot find the file specified.

[Franklin97355]

What port is your arduino on?

[kenyajr]

com4 I had it on another port but i couldn't get it to load so now it loads but it seems to stop

[kenyajr]

Not sure how I started another topic. Testing to make sure...

[Franklin97355]

now it loads but it seems to stop

can you explain in more detail? What are you loading and what messages do you get?

[kenyajr]

No I am not getting an error message. I am following the tutorial which says
If you upload the demo to your wired-up Arduino and open the serial monitor you should see that it starts advertising BLE signal

I don't see that it 'starts advertising'
I just get the first line Adafruit Bluefruit Low Energy nRF8001 Print echo demo
I downloaded the android app to test this and all it doesn't detect the board