Hi,
connected I2C servodriver to arduino
load I2C-Scan sketch and run
Driverbord is the only board on the I2C-bus
But I see 2 address 0x40 the basic adres and the other adres is 0x70 ?????
And that 0x70 is olso the base adres from the sonar SRF08
So both together did not work so I changed the SRF08 adres and ok!
But my question is where is that 0x70 from ???????
adafruit servoboard+arduino mega
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Franklin97355
- Posts: 23910
- Joined: Mon Apr 21, 2008 2:33 pm
Re: adafruit servoboard+arduino mega
The 0x70 is a "broadcast" address for the servo driver to communicate with all the servos at once.
Please be positive and constructive with your questions and comments.