Does Adafruit produce a housing or shell for TVBGone? The raw power I feel coming off this tiny device is intimidating, plus I feel I might break the cables (again).
If you don't make one, are there some general DIY hints about creating something to protect it?
Housing or casing?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 11
- Joined: Mon Sep 23, 2013 10:28 pm
Re: Housing or casing?
Would Sugru do the trick?
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: Housing or casing?
People have hidden them in all sorts of clever containers: Mint tins, old cell-phone cases, flashlights, hats, ties, sonic screwdrivers etc. I'm sure a lot could be done with Sugru too.
http://www.adafruit.com/products/97
http://www.adafruit.com/products/97
-
- Posts: 11
- Joined: Mon Sep 23, 2013 10:28 pm
Re: Housing or casing?
If I used Sugru to adhere the circuit card to the battery case, would there be any electrical problems? Shorts or crossed pulses?
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: Housing or casing?
No. Sugru is non-conductive.
-
- Posts: 11
- Joined: Mon Sep 23, 2013 10:28 pm
Re: Housing or casing?
http://forums.adafruit.com/viewtopic.php?f=23&t=44925
Link is to my final product.
Chose silicon glue instead and an eyeglasses case.
Thanks for the help.
Link is to my final product.
Chose silicon glue instead and an eyeglasses case.
Thanks for the help.
Please be positive and constructive with your questions and comments.