I CANT UPLOAD A SKETCH

[fendetestas]

Hello, I recently bought two chips ATmega328 with bootloader, I have placed on my Arduino Duemilanove and when I try to upload a sketch I get the following error:
avrdude: stk500_getsync (): not in sync: resp = 0x00,
What can I do?
WINDOWS 7 ULTIMATE 64
BOARD ARDUINO DUEMILANOVE w/ATMEGA328
USB SERIAL PORT (COM4)
MANUFACTURER FTDI
LOCATION USB SERIAL CONVERTER
DRIVER VERSION 2.8.14.0
DRIVER DATE 03/18/2011

[adafruit_support_bill]

I recently bought two chips ATmega328 with bootloader

What kind of bootloader is on the chips? Did you buy them from Adafruit?

[fendetestas]

The chips are ATMEGA328P-PU, and I have bought a week ago adafruit

[adafruit_support_bill]

I have bought a week ago adafruit

Then they should have the Adaboot bootloader.

In the IDE, select File->Preferences and check "Show Verbose Output During Upload".

Do an upload and post the diagnostic output here.

[fendetestas]

When I upload shows:
avrdude: stk500_getsync(): not in sync: resp=0x00

[adafruit_support_bill]

Scroll up and get all of the text. If you have enabled verbose output for upload, there should be more diagnostic data.

[fendetestas]

Well, problem solved, it was a problem of the board (chinese), had to remove a resistor (R2), and now works perfectly, thanks for your help.

[adafruit]

Well, problem solved, it was a problem of the board (chinese), had to remove a resistor (R2), and now works perfectly, thanks for your help.

just for fun, can you post a photo of the "chinese board" ?

thank you!
adafruit support, phil

[fendetestas]

Yes, you can see in the link below.
http://www.dealextreme.com/p/arduino-du ... 36?item=30