Motor Shild
Moderators: adafruit_support_bill, adafruit

Motor Shild

by lbaroudi on Mon Feb 04, 2013 12:06 pm

Hello there,

I need to make 4 AC motors controll 110/220 V also need to findout each motor consumption motor size is 4 amp at the max, please advice which shield or design can be sufficient, I also want to put water level reader based on ultra sound or tank deeper then 3 meters or other type of measurement's please advice what arduino to use?

Regards,
Labib
lbaroudi
 
Posts: 15
Joined: Tue Dec 07, 2010 11:46 am

Re: Motor Shild

by adafruit_support_bill on Mon Feb 04, 2013 12:15 pm

For AC motors you would need a relay circuit. The PowerSwitchTail contains a relay and an interface to drive from an Arduino: http://www.adafruit.com/products/268

For measuring water levels, the Maxbotix Weather Resistant sensor would be the best choice: http://www.adafruit.com/products/1137

Any Arduino can control these devices. An UNO is a good choice: https://www.adafruit.com/products/50
User avatar
adafruit_support_bill
 
Posts: 30887
Joined: Sat Feb 07, 2009 10:11 am