Good morning dear forum
I am planning a 2.8 "TFT Touch Shield for Arduino to use v2. purpose, it is very important for me to know how thick the whole part. unfortunately I could not find this information anywhere. Could you help me urgently, please?
Thank you.
Best Regards
Alex
2.8 "TFT Touch Shield for Arduino
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88037
- Joined: Sat Feb 07, 2009 10:11 am
Re: 2.8 "TFT Touch Shield for Arduino
Are you looking for the full height of the shield stacked on an Arduino, or just the shield itself?
- driftergoerz
- Posts: 4
- Joined: Wed Jan 15, 2014 3:25 am
Re: 2.8 "TFT Touch Shield for Arduino
I am looking for the full height of the shield stacked on an Arduino. Thanks
- adafruit_support_bill
- Posts: 88037
- Joined: Sat Feb 07, 2009 10:11 am
Re: 2.8 "TFT Touch Shield for Arduino
OK. We'll put one together and should have an answer for you tomorrow.
- driftergoerz
- Posts: 4
- Joined: Wed Jan 15, 2014 3:25 am
Re: 2.8 "TFT Touch Shield for Arduino
That´s great, thank you very much!!!
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: 2.8 "TFT Touch Shield for Arduino
Including the barrel-jack solders on the bottom of the Uno, it's 20.7mm.
Not including the solders (i.e, to bottom of the board) it's 19.2mm
Not including the solders (i.e, to bottom of the board) it's 19.2mm
- driftergoerz
- Posts: 4
- Joined: Wed Jan 15, 2014 3:25 am
Re: 2.8 "TFT Touch Shield for Arduino
Thank you so much for your help. Fantastic! Now I am ready to build my prototype for aquarium lights...
Best regards
Alex
Best regards
Alex
Please be positive and constructive with your questions and comments.