Adafruit PN532 NFC/RFID Controller Shield with Arduino Mega

[Raveenb]

I recently punched your Adafruit PN532 NFC/RFID Controller Shield for Arduino. The shield work with the following freetronic Arduino

EtherTen - http://www.freetronics.com/collections/ ... s/etherten
USBDroid - http://www.freetronics.com/collections/ ... s/usbdroid
Eleven - http://www.freetronics.com/collections/ ... cts/eleven

But with the EtherMega (http://www.freetronics.com/collections/ ... d-ethernet) , I am getting "Didn't find PN53x board”.

I have tried both I2C and SPI mode and none of them works. Can you please let me know what are the changes requited to get this shield working with Arduino Mega.

Thanks

[adafruit_support_bill]

The shield is designed for the R3 and later MEGA. Earlier models require some jumper wires. From the product description:

Compatible with any "classic" Arduino - NG, Diecimilla, Duemilanove, UNO - as well as Mega R3 or later. For using the I2C interface with Mega R2 or earlier, two wires must be soldered as the I2C pins are in a different location on earlier Megas.

[Raveenb]

Thanks, It Works.

Is there any example code to use this NFC with NETduino

Thanks

[adafruit_support_bill]

Is there any example code to use this NFC with NETduino

We don't have any here. You might check over at the NETduino site.