Mifare read/write question
Moderators: adafruit_support_bill, adafruit

Mifare read/write question

by Sy Illusions on Fri Nov 09, 2012 10:38 pm

I'm curious if it's possible to read/write a single eeprom address on a MiFare classic 1k card, instead of an entire "block" using the Adafruit NFCShield I2C library?

Hardware setup as follows
Arduino Uno R3
Adafruit PN532 NFC/RFID Controller Shield for Arduino
MiFare Classic (13.56MHz RFID/NFC) Bracelet - 1KB
Sy Illusions
Posts: 1
Joined: Fri Nov 09, 2012 10:17 pm

Re: Mifare read/write question

by adafruit on Fri Nov 16, 2012 12:19 am

you can check the PN532 datasheet for details - but in general EEPROMs are written block by block

Posts: 11884
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc