Torque Vs Speed Curve

Adafruit Ethernet, Motor, Proto, Wave, Datalogger, GPS Shields - etc!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
TomSiv
 
Posts: 4
Joined: Wed Aug 28, 2013 8:01 pm

Torque Vs Speed Curve

Post by TomSiv »

Hello,

I recently purchased a 12v 350 mA, 200 Step/rev stepper motor and I would like to see the Torque vs Speed curve from the manufacturer, but it is not available under the technical information or in the data sheet. Is there anyone who can provide me to this or point out if I'm missing it in an obvious place? Thank you very much.

User avatar
adafruit_support_mike
 
Posts: 67446
Joined: Thu Feb 11, 2010 2:51 pm

Re: Torque Vs Speed Curve

Post by adafruit_support_mike »

The datasheet: http://www.adafruit.com/datasheets/12vstepper.jpg is the only documentation we have. For more detail you'll need to run a series of measurements for the operating conditions you expect to use.

Locked
Please be positive and constructive with your questions and comments.

Return to “Arduino Shields from Adafruit”