Motor Shield V2

Adafruit Ethernet, Motor, Proto, Wave, Datalogger, GPS Shields - etc!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
asterof
 
Posts: 11
Joined: Tue Feb 02, 2016 6:50 pm

Motor Shield V2

Post by asterof »

Just got my unit, I am somewhat confused on the pin connectors that came with it
I also ordered the Arduino Stacker Set
So the pin set that came with it does it need cut
also does it need soldered into the shield ?
What if I need to stack another board on top of it
Is there a document or video that shows this
Thanks

User avatar
adafruit_support_bill
 
Posts: 88093
Joined: Sat Feb 07, 2009 10:11 am

Re: Motor Shield V2

Post by adafruit_support_bill »

If you are using the stacking headers, you don't need the regular headers. Just save them for your next project.

Soldering stacking headers to a shield is documented here: https://learn.adafruit.com/adafruit-pro ... ng-headers

Locked
Please be positive and constructive with your questions and comments.

Return to “Arduino Shields from Adafruit”