Hi,
I am using a USB-Serial cable that is connected to the DASA kit you sell. The DASA is connected to the Fuzebox. The Fuzebox is powered up and I run avrdude to try reading from the chip but I am not able to do it.
I already tried video, audio and bootloader so everything seems fine. What can I do to communicate with the Atmega?
P.S. When I "unplug" the DASA from the board the LED blinks three times as if a reset is being performed
DASA not working
Moderator: adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: DASA not working
unfortunately the dasa programmer is too 'crappy' to program it you would need to put a buffer on the programmer lines because they are being too dragged-down by the SD card resistors. alternately you can just 'clip' the SD card resistors. i dont think SD support has been really nailed down anyways
-
- Posts: 3
- Joined: Fri Dec 12, 2008 2:09 pm
Re: DASA not working
In this case, if I use the USB TTL would mean I won't have this issues?
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: DASA not working
yes it would be OK, assuming that you have a kit or a preprogrammed fuzebox chip with the bootloader
Please be positive and constructive with your questions and comments.