Dear Officer
I am looking for tutor or some instruction to show me how to connect...
Adafruit Motor/Stepper/Servo Shield for Arduino v2 Kit (v2.0) [ID:1438]
to Raspberry PI.
Would you guide me the link please
Regards,
P.U. COMPONENT
Tutor Please
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88087
- Joined: Sat Feb 07, 2009 10:11 am
Re: Tutor Please
We do not have a library or tutorial for that configuration. Connection is fairly straightforward, just 4 pins.
GND->GND
5v->5v
SDA->SDA
SCL->SCL.
It is necessary to configure the i2c for 3.3v levels. This is described here: http://forums.adafruit.com/viewtopic.ph ... 89#p227877
We do not have a library for the Pi. The Arduino Library is written in C++ and would be the best reference for how to communicate with the shield.
https://github.com/adafruit/Adafruit_Mo ... V2_Library
GND->GND
5v->5v
SDA->SDA
SCL->SCL.
It is necessary to configure the i2c for 3.3v levels. This is described here: http://forums.adafruit.com/viewtopic.ph ... 89#p227877
We do not have a library for the Pi. The Arduino Library is written in C++ and would be the best reference for how to communicate with the shield.
https://github.com/adafruit/Adafruit_Mo ... V2_Library
-
- Posts: 13
- Joined: Sat Dec 07, 2013 2:52 am
Re: Tutor Please
Thank you for your support
See you on the next question
See you on the next question
Please be positive and constructive with your questions and comments.