I'm an artist working on my first solo show, which involves a set build and light installation using Neopixel WS2812 RGB LED Stripe - 60 LEDs/m . I have little knowledge of Arduino (although I have recently been fabricating LED light panels and incorporating both Neopixel and Arduino into the design), and have limited experience using LED's. For the installation I will be building a platform in the gallery and running a strip of LED's under the edge to light the walls. The required length of the LED's is 25m, and I need to workout how to properly power and wire these, and problem solve any control issues with Arduino (I've purchased an UNO). I would appreciate any assistance and advice with this project which is definitely a personal challenge, and something I have to get right...... I've attached a 3d render that visualises the space.
Solo Show Light Installation (Neopixel & Arduino)
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Visual_Artist
- Posts: 7
- Joined: Fri Jan 30, 2015 6:41 am
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: Solo Show Light Installation (Neopixel & Arduino)
Please do not double-post.
Please be positive and constructive with your questions and comments.