I have an XbeePro shield and it's connected to an Arduino 328 (Duemilanove); the dout pin on the Xbee is showing 5V, the same as the Rx pin on the Arduino. How can a shield be so miswired?
I assume that's why it's destroying Xbee's?
Blowing Xbee Series 2
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 12151
- Joined: Thu Apr 06, 2006 4:21 pm
Re: Blowing Xbee Series 2
its likely. you should contact the makers of the xbee shield. adafruit does not produce or sell xbee shields
Please be positive and constructive with your questions and comments.