XBee Arduino programmer issues on Arduino Uno REV3
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

XBee Arduino programmer issues on Arduino Uno REV3

by joshlucy on Tue May 29, 2012 2:21 pm

Hello all, I followed the instructions at http://www.ladyada.net/make/xbee/arduino.html to build a wireless XBee programmer and I've been having a great deal of difficulty making the programmer work. I'm able to do serial debugging, and the reset function works but I've been getting error messages when trying to program the unit:

avrdude: stk500_getsync(): not in sync: resp=0x1e

I've tried using the following baud rates: 56700 (current), 19200, and 115200 [by default the software is programming at this speed over USB so I figured I'd give it a try]. I only seem to get debugging data sent by Serial.println() and related. Does anyone know if there's something different that needs to be done on the Uno R3 to make wireless programming work?

joshlucy
 
Posts: 4
Joined: Tue May 29, 2012 2:11 pm

Re: XBee Arduino programmer issues on Arduino Uno REV3

by adafruit_support_bill on Wed May 30, 2012 6:30 am

I'm able to do serial debugging, and the reset function works

So you see the board reset when you start the upload? There should be a few quick flashed from the LED.

adafruit_support_bill
 
Posts: 39301
Joined: Sat Feb 07, 2009 10:11 am

Please be positive and constructive with your questions and comments.