I hope this is the right section for this query, and I have checked around but found no relevant solutions to my problem.
I am working on a fairly simple project (that actually has been featured here on the blog!) involving
a potentiometer and a servo. In its most basic setup it's the knob sketch, and it builds up from there.
You can check out the project here:http://adisoffer.tumblr.com/post/25422476290/you-read-the-post-now-watch-the-movie-arduino-follow
I'm trying to go wireless now and the simple task of communicating with my XBee with a usb adapter is a total fail :|
I've downloaded x-ctu, I've downloaded the drivers, I've changed the ports and the baud rates but I get no communication.
I don't think the modules are faulty, and I believe I'm doing a most basic mistake that I simply am not aware of.
I would appreciate some tips and input and would be happy to supply any additional info to get this thing working...