Re: monochron fails LED + switch test
Thank you so much for your help, and thank you for keeping the kids gloves on!
I'm not sure what to make of this but here is what I observed:
I only ever saw 0 volts between +5V and GND, no matter the position of the switch. I touched up the solder a bit, but still never saw anything between them.
Switch in position shown:
-0 between GND and switched GND/NC
5.08V between +5V and switched GND/NC
-0 between NC and switched GND/NC
0.4 (fluctuated) between +5V and switched GND/NC
Thank you again for your help.