Hi,
I am building the Ice Tube Clock kit. After assembling 5V powersupply, ATmega, and buzzer, there is no beep.
How can I check whether the ATmega is correctly programmed? Power supply checks out OK.
MT
--
Ice Tube Clock: 5V + ATmega, no beep
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: Ice Tube Clock: 5V + ATmega, no beep
Post photos of the front and back of your board so we can check your assembly.
-
- Posts: 3
- Joined: Fri May 24, 2013 11:51 am
Re: Ice Tube Clock: 5V + ATmega, no beep
Photos attached.
MT
--
MT
--
- Attachments
-
- boardBack.jpg (78.09 KiB) Viewed 1188 times
-
- boardFront.jpg (90.67 KiB) Viewed 1188 times
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: Ice Tube Clock: 5V + ATmega, no beep
The assembly looks pretty clean so far. A mis-programmed chip is a reasonable diagnosis. Contact [email protected] with a link to this thread and ask for a replacement Ice Tube Processor.
-
- Posts: 3
- Joined: Fri May 24, 2013 11:51 am
Re: Ice Tube Clock: 5V + ATmega, no beep
Received and installed new chip: it now beeps as expected.
Thanks,
MT
--
Thanks,
MT
--
Please be positive and constructive with your questions and comments.