had many hands-on session for SMT equipment last week ... WOW ...
The printer, I got it, I like it. For what I need, I can recommend it. If you do low volume, many different designs, even one-offs I think this is really good value-for-money.
The Oven, not sure....
It does quite well, but the board has to be fairly small, no more than 15-20cm, in this center Area, temp stays within 5deg.C. - Around this, we measured differences from up to 20 deg.C., lower. Again, the overall thing still seems good value for money, just .... not sure.
The feedback for the Oven might not very helpfull, but, that is just my impression. Looking for perfection, which I possibly canßt get for this budget :(
No decision yet, keep you posted!