I purchased a DSO Nano v3 last week. When I powered the unit on after charging, the software version number was 4.28. The single channel wasn't working and the display was showing "USB" in the top right corner, the USB cable was not connected (pic attached). Then the screen went blank and stayed like that until I reset power (pic attached). The scope does the exact same thing over and over.
Adafruit PID#: 468
Date of Purchase: 3/13/2015
Order#: 734946-2558533859
Invoice#: 734946
DSO Nano v3 not working out of the box
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- n8provance
- Posts: 1
- Joined: Mon Dec 22, 2014 2:30 am
DSO Nano v3 not working out of the box
- Attachments
-
- Showing USB in top right but no cord is connected
- usb.PNG (914.94 KiB) Viewed 663 times
-
- This is the screen that shows after about 2 minutes. Stays like this until I reset power. Then returns to this screen on reboot
- blank.PNG (678.36 KiB) Viewed 663 times
- adafruit_support_rick
- Posts: 35092
- Joined: Tue Mar 15, 2011 11:42 am
Re: DSO Nano v3 not working out of the box
We haven't seen any DOAs out-of-the-box. Can you post on the seeed forums to see if they can help you?
http://www.seeedstudio.com/forum/viewfo ... c23e5d2c57
http://www.seeedstudio.com/forum/viewfo ... c23e5d2c57
Please be positive and constructive with your questions and comments.