7-Segment Backpack min brightness still very bright
Moderators: adafruit_support_bill, adafruit

7-Segment Backpack min brightness still very bright

by dlchambers on Sat Dec 01, 2012 3:07 pm

To start off, I'll say that the backpack is a great product and it couldn't be easier to use.
That said :wink:...
The backpack allows you to set the display's brightness (eg. Arduino lib's setBrightness() fcn) from 0 to 0x0f.
Unfortunately, the minimum setting (0) is still quite bright - excessively bright in a dark room.
I was hoping to use it on my bedside table, like an alarm clock, but it's way too bright for that.
Given that this is probably just a PWM thing, why not allow the user to set the duty cycle between 0% and 100% ?
dlchambers
 
Posts: 9
Joined: Thu May 12, 2011 3:23 pm

Re: 7-Segment Backpack min brightness still very bright

by adafruit on Sat Dec 01, 2012 10:10 pm

Unfortunately, we're stuck with whats in the hard-coded chip software. The chip itself doesn't support anything dimmer than 1/16th brightness. perhaps you could cover it with a neutral filter to dim it more?
User avatar
adafruit
 
Posts: 11712
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc